Stick Communications

STICK "dial into remote computer"

This command is used to dial into another computer running the STICKR program.
The phone number to dial must be the first parameter specified on the command line.

STICKR "get computer ready for dial-in"

This program will initialise the com port and the modem, ready to automatically answer an incomming call and start communicating with the STICK program.

General Command Line Parameters

Syntax: stick[r] [phone_number] [p=n] [irq=n] [base=n] [enable=n]

phone_number	Specify the phone number to dial (STICK only).
p	Com port 1-4, leave blank and system will auto-detect.
irq	Specify the IRQ if different from the default for the selected com port.
base	Specify the I/O base address if different from the default; Hexadecimal.
enable	Interupt enable flag (0f7 or 0ef), if different from default; Hexadecimal.
speed	Specify the baud speed, either 2400 or 9600 (default 9600).

Examples

stick 1,043850619 p=3 irq=10 base=3f8 System will set com port 3, irq 10, base 3f8. The enable flag will use use the default. The speed will default to 9600.
stickr irq=10 Stickr will auto-detect the com port but then force the use of IRQ 10. All other com port settings will default to the selected com port.
stickr p=2 Stickr will use com port 2, all other defaults will be used.